Ask The County Agent: Pruning Gardenias

By STEPHANIE BUTCHER, UGA-Coweta County Extension Coordinator

QUESTION: Should I prune my gardenias right now or should I wait?

AGENT: Gardenias should be pruned after their blooms begin to fade in the summer. They will set buds on old wood, so if you wait too long to prune, then you will prune off the buds.  

Pruning plays an important role in the health, productivity and well-being of woody plants. Knowing when to prune flowering plants or evergreen plants can be confusing, so here are some basic rules that will help you determine when to prune your landscape plants. 

Timing

• If the plant blooms in the spring — like an azalea, dogwood, forsythia or mophead hydrangea — it should be pruned right after blooming. Spring flowering plants form their flower buds in the fall. If these plants are pruned in late winter, the flower buds will be removed and there will be no spring flowers to enjoy.
• If the plant blooms in the summer, prune in late winter — late February to early March — while the plant is still dormant.
• If plants are not grown for their flowers, the best time for pruning is during the dormant winter season — late February to early March — before new growth begins in the spring.
• Do not prune during the late summer and fall because new growth may occur and make the plants more susceptible to cold injury.

There are some exceptions to these rules. Remove anything that is dead or diseased any time of the year. Another exception is to clean up the overall appearance of a spring bloomer that has not been pruned in a very long time. For example, if an azalea is 10 feet tall and scraggly and doesn’t flower well, then it can be pruned it in the late winter to clean it up. The plant won’t flower in the spring, but it will at least have a healthy start in the spring and will bloom the following year.

Tool sanitation

Always use clean pruning shears and be sure to sanitize the shears after each use. This is easily accomplished by dipping them in or wiping them down with 70% isopropyl alcohol. Some people use a 10% bleach solution for this purpose, but bleach tends to have a corrosive effect on tools over time.  

Technique

There are two main types of cuts that you can make while pruning. One is called a “heading cut,” in which the tips of branches are removed. This type of pruning is used to create dense regrowth near the cut, as would be expected in a hedge. The other type of cut that is often used is a “thinning cut,” in which an entire branch is removed at its base on the main stem or along a larger branch. Thinning allows more light to enter the shrub and is the preferred method if the pruning goal is to maintain a natural form.

When making cuts, look for the raised ridge of bark around the shoot that you are pruning, and make your cut so that that ridge is left intact. Tissue in this ridge of bark will help promote the cut to seal so, if you damage it, you may be inviting problems. It is also important to cut close enough to this ridge not to leave a stub, which also can slow the sealing process.

Use the three-cut method to avoid damaging the bark around the cut. Steps of the three-cut method are:

1. Cut a notch above where you plan to make your final pruning cut.
2. Cut the branch off above the notch to remove the weight of the branch — this will leave a stub.
3. Make your final cut just above the branch bark ridge, leaving a clean opening that can begin to seal. 

For more information on pruning, contact the Coweta County Extension office at 770-254-2620 or email [email protected] and ask for the publication, Basic Principles of Pruning Woody Plants. 

The University of Georgia College of Agricultural & Environmental Sciences is an equal opportunity, affirmative action organization.

Photo Credit: Sharon Dowdy, UGA CAES/Extension